Agworld DBX empowers you with the right crop input label information for informed pest management & plant protection, powered by Greenbook.

Mocap 15G Lock'n Load

AMVAC
Restrictions

Available for use in the following states

Available

Not available

Danger
Product safety

Protections

Early entry
coveralls over long-sleeved shirt and long pants, chemical-resistant gloves made of any waterproof material chemical-resistant footwear plus socks, and protective eyewear.
Personal Protection
Some materials that are chemical-resistant to this product are barrier laminant, butyl rubber (≥14 mils), nitrile rubber (≥14 mils) or Viton (≥14 mils). Loaders, applicators, and other handlers using engineering controls must wear: long-sleeved shirt and long pants, and shoes plus socks Handlers engaged in those activities for which use of an engineering control is not possible, such as cleaning up a spill or cleaning or repairing contaminated equipment, must be provided with and have immediately available and must use in an emergency: coveralls over long-sleeved shirt and long pants chemical-resistant gloves, chemical-resistant footwear plus socks, chemical-resistant headgear for overhead exposure, and a non-powered air-purifying respirator equipped with an N, R, or P-series filter. ENGINEERING CONTROLS This product is formulated into a LOCK‘N LOAD system that meets the definition of a closed loading system in the Worker Protection Standard for Agricultural Pesticides [40 CFR 170.240(d)(4)]. In addition, loaders must: wear PPE specified in the PPE section of this labeling, be provided with, must have immediately available and must use in an emergency, such as a broken package, spill, or equipment breakdown, the PPE specified in the PPE section of this labeling for handlers engaged in those activities for which use of an engineering control is not possible. Applicators using motorized ground equipment must use an enclosed cab that meets the requirements listed in the Worker Protection Standard (WPS) for agricultural pesticides [40 CFR 170.240(d)(5)] for dermal protection. In addition, applicators must: wear the personal protective equipment required above for applicators, either wear the type of respirator specified in the PPE section of this labeling or use an enclosed cab that is declared in writing by the manufacturer or by a government agency to provide at least as much respiratory protection as the type of respirator specified in the PPE section of this labeling, be provided and have immediately available for use in case of an emergency when they must exit the cab, the PPE specified in the PPE section of this labeling for handlers engaged in those activities for which use of an engineering control is not possible, take off any PPE that was worn in the treated area before reentering the cab, and store all such PPE in a chemical-resistant container, such as a plastic bag, to prevent contamination of the inside of the cab.
Restricted Entry Interval
48 hours

Precautions

May be exposed to direct sunlight

Is not vulnerable to flame or sparks

May be stored in a damp place

May be stored in a warm place

May be frozen